How to Setup a Netgear Wireless Router?

In This Post, we’ll make a case for a way to Install Your Netgear Router along with your web electronic equipment. we’ll conjointly Guide You thoroughly All Tricks that you just will strive whereas putting in Netgear Wireless Router.

Friends we will Bet You That putting in Router Would ne’er Take over ten Minutes If You follow the correct Steps.

Friends putting in Any Home Wireless Router Is just about Same except for 1-2 Steps. Having aforementioned That we might prefer to inform You That Doing Wrongful Installation will price You issues over you’ll Imagine.

How to Setup Netgear Wireless Router. It is often a troublesome method to line up a wireless router and a Windows shopper. There square measure variety of choices that got to be understood before you begin, and it is easy to create a wrong flip. Luckily, once you have got a router, each Windows and Netgear offer in small stages programs for fitting your wireless local area network.

Setup Netgear Wireless Router

Step. 1

Decide on a Netgear router. There are a number of router offerings, and prices and features differ depending on the model. Choose one that meets your needs and fits your price range.

Step. 2

Purchase a Netgear router, looking for the best price possible. Consumer electronics shopping sites like NewEgg and TigerDirect often offer good deals on clearance, open boxes or shipping (see Resources below).

Step. 3

Place the router by clearing a space on or under a desk. The router should be located centrally to reduce the distance to clients and assure better connections. The location will vary depending on how it will be used. For example, it shouldn’t be placed in the corner of a basement if wireless clients all over the house will be using it.

Step. 4

Set up and plug in the Netgear router and wait a few seconds for it to boot up. Since the router is essentially a mini-computer, it won’t work instantly when it’s turned on. While it’s booting, the power light should flash. When it’s finished booting, the power light should stay solid.

 

Step. 5

Connect a computer to the router, either with a wireless or a wired connection. Reboot the computer to ensure it gets a new IP address from the router via Dynamic Host Configuration Protocol (DHCP).

Step. 6

Open the web interface by entering “http://192.168.1.1/” into the address bar of your web browser. If a login screen is presented, use “admin” as the username and either “1234” or “password” as the password.

Step. 7

Connect to the Internet, if necessary. Plug your cable modem or DSL modem into the router’s WAN port in the back and run the Internet Connection Setup Wizard from the web interface.

Step. 8

Follow the directions and provide authentication information.

Step. 9

Connect more clients. At this point, clients should be able to connect and access the Internet.

Add a Comment

Your email address will not be published. Required fields are marked *